Kichler 15735 Uživatelský manuál stáhnout pdf

Kichler Design Pro LED Under Rail Fixture Installation Instructions

P/N: 15735AZT/BBR/CO, 15736AZT/BBR/CO, 15755AZT/BBR/CO

Dev. No: CP300349AZT/BBR/CO, CP300350AZT/BBR/CO, CP300351AZT/BBR/CO

READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION

KEEP THESE INSTRUCTIONS

This ﬁxture is intended for installation in accordance with the National Electric Code (NEC) and Local code speciﬁcations.

Failure to adhere to these codes and instructions may result in serious injury and/or property damage and will void the warranty.

1) WARNING: This ﬁxture is not to be installed within 10 feet (3M) of a pool, spa, or fountain.

2) This ﬁxture is to be used only with a power unit (transformer) rated a maximum of 300 W (25 AMPS) 15 volts.

3) The 18AWG ﬁxture wire is not intended for direct burial.

4) Direct burial rated wire is to be buried a minimum of 6” (152mm) beneath the surface of the ground. NOTE: If additional Direct Burial

wire is needed, contact your local Kichler® landscape distributor.

  • 8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

  • 10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

  • 12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’(76M),15502-BK;500’(152M),15505-BK;and

   1000’(304M),15506-BK.

5) DO NOT INSTALL under stairs where the tread overhangs the riser less than ¾” [19 mm]

6) Wiringconnectionsmustbemadewithapproved/listedwireconnectiondevice(s)suitablefortheapplication.Donotexceedmanufacturers’

wiring combination speciﬁcations for size and quantity of conductors.

INSTALLATION OF 15735, 15736, or 15755, IN RAILING, DECK OVER-HANG OR STAIR

(SEE FIG. A)

1) Turn off power.

2) Determine the desired location for the ﬁxture. If using 15717, 15718 or 15719 accessory, please refer to accessory instruction sheet.

3) If desired, a wireway hole can be drilled through the decking fascia or other surface adjacent to the mounting surface.

a. Hold the ﬁxture in the desired mounting location. Mark the location where the wire exits the ﬁxture.

b. Drill hole though surface. (suggested ¼” [6.5 mm] hole)

c. Thread the wire through the hole.

4) Install ﬁxture using #8 wood screws (provided). If screws are difﬁcult to install, mark holes and drill 1/8” pilot holes.

NOTE: DO NOT OVER TIGHTEN SCREWS.

5) Connect ﬁxture wires to main low voltage supply cable using the connector(s) provided.

FIG. A

Date Issued: 6/25/10 IS-15735-CB

WARRANTY

WE WARRANT THE LANDSCAPE PRODUCTS FEATURED IN OUR LANDSCAPE LIGHTING CATALOG (WITH THE EXCEPTION OF LIGHT BULBS) FOR FIVE YEARS AGAINST

DEFECTS IN MATERIALS AND WORKMANSHIP IF IT WAS PROPERLY INSTALLED AND FAILED UNDER NORMAL OPERATING CONDITIONS, PROVIDED IT IS RETURNED TO

THE POINT OF PURCHASE, WHERE IT WILL BE REPAIRED OR, AS IT MAY BE DETERMINED, TO REPLACE THE LANDSCAPE PRODUCT OR PARTS USED ON THAT PRODUCT.

QUIC DISC

™

WIRING INSTRUCTIONS

Turn off power.

The full length of the 18 GA ﬁxture wire may be used to connect with the 10 GA or 12 GA cable provided the following conditions are

met:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install one ﬁxture and accommodates one 18 GA ﬁxture wire and one 10 GA or one 12 GA

supply wire.

Place the 10 gauge supply wire across the area marked 10 GA on Quic Disc

™

or place the 12 gauge supply wire across the area

marked 12 GA on Quic Disc

™

Place the 18 gauge ﬁxture wire across the area marked 18 GA on the Quic Disc

™

. After the wires are in place, connecta the top of the

Quic Disc

™

to the base with supplied screw, making sure that the wires remain ﬂat in the bottom portion of the Quic Disc

™

, and the

screw is tightened all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Make no other wiring connections to the 18 GA ﬁxture wire.

OUTDOOR USE ONLY

DOM ETRE INSTALLE A L’EXTERIEUR

INSTRUCTIONS

For Assembling and Installing Fixtures in Canada

Pour L’assemblage et L’installation Au Canada

1 2

Kichler Design Pro DEL 2

Shrnutí obsahu

Strany 1

Kichler Design Pro LED Under Rail Fixture Installation InstructionsP/N: 15735AZT/BBR/CO, 15736AZT/BBR/CO, 15755AZT/BBR/CO

Strany 2 - Kichler Design Pro DEL

Kichler Design Pro DELInstructions de montage pour luminaire sous rampeP/N: 15735AZT/BBR/CO, 15736AZT/BBR/CO, 15755AZT/BBR/CO

Příbuzné modely 15736 | 15755 |

Další dokumenty pro Osvětlení Kichler 15735

Zobrazit dokument Kichler 15735 Uživatelský manuál

Kichler 15735 Uživatelský manuál (2 stránky)

Komentáře k této Příručce

Žádné komentáře

Kichler 15735 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Kichler 15735. Kichler 15735 Manuel d'utilisation Uživatelská příručka

Shrnutí obsahu

Příbuzné modely 15736 | 15755 |

Další dokumenty pro Osvětlení Kichler 15735

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Kichler 15735